Insert the lens in any direction and remove after a short period of time is measured, centered and blocked is ready for edging process. Determination of drill hole coordinates included!
The WECO Verifier Pro is a high-tech product solution integrating a centring device and a lensmeter. In the operating sequence it is no longer necessary to mark spectacle lenses on the lensmeter, as the task of measuring, centring and blocking lenses is performed in an automated operating sequence.
Insert the lens in any direction and remove after some seconds is measured, centered and blocked is ready for ginding.
Measuring is precisely and without risk.
- Measurement of single vision-, bifocal- and progressive lenses
- Detection of values for near and far vision of multiple focus lenses
- Detection of reference points, cylinder shafts, detection points of progressive lenses
- Detection of the raw glass margin
Centring is non-complicated and without parallax error.
Blocking is automatic and without block error.
- Calculates the position of reference point inside the form
- Calculation of the block point
- Overlapping degree between the raw glass and the form is checked
- Calculates the best position of the lens
Calculating drilling hole coordinates is quick and uncomplicated.
- Determination of drilling hole coordinates via easy mouse click
- To avoid errors the lens including drill holes is displayed